FLAPERON ASSEMBLY (CONTINUE)

INBOARD RIGHT FLAPERON

Inspection of the Flaperon to check the tolerance.

Full Rib was clecoed to the bottom of the Skin. The initial holes were expanded using #30 drill bit and clecoed the Full Rib to the Skin. The length from the Full Rib to the hole was measured using Rivet Fan.

Initial drill through the back of the Skin into Ribs and Spar using #40 drill bit,clecoed as the holes was drilled. Next,these clecoed holes were expended with #30 drill bit. 

Clecoed process.

The thread was used to hold the skin around the Nose Ribs and clecoed the Skin to the Spar.

Complete clecoed holes assembly of the Skin.

The final Flaperon after clecoed.