INBOARD RIGHT SLAT ASSEMBLY

The bottom of the Slat Skin was drilled with a #40 drill bit and clecoed with #40 PWN Cleco series (zinc colour).

Later, the hole was expanded with #30 drill bit and clecoed with #30 PWN Cleco series         (copper colour).

The Slat Rib and Slat Skin was clecoed using #40 Temporary Sheet Metal Fastener (red colour).

Next, the Slat Rib and Slat Skin were expanded with #30 Temporary Sheet Metal Fasteners (yellow colour).

The Slat was flipped over and clecoed with #40 PHD Cleco series.

Finally, all holes were clecoed on the Top of the Skin.