OUTBOARD RIGHT SLAT

The Ribs was clecoed with #30 Celco to the bottom of the Skin.

Drilled #30 drill bit at teh leading edge of the Rib through the Skin.

Flipped the Slat over and set it on the beams. Clecoed the Ribs to the top Skin.

The top of the Skin was clecoed with a #40 Grip Pin and Cleco.

With a #30 drill bit, expand the holes through the Skin at the bottom of the Ribs, L angles , and Corner Doubler.

Expand the hole with #30 drill bit and clecoed every hole for the aft rivet line on the Top of the Skin.

Drilled and clecoed with #30 Cleco at the aft rivet line at the bottom Skin.

The completed Outboard Right Slat Assembly.