19 September 2011

19 September 2011

Slat Rib (Predrilled for the slat support)

The L angle was bended to match the bottom curvature of the Rib. The L angle is positioned with

the 50mm section of the L angle towards the aft end of the Rib. The Rib was drilled with #40 drill bit into the

L angle and was clecoed to the Rib

Slat Support

The Slat Support was clecoed between the L angle and the Rib. The holes were

expanded with a #30 drill bit.

The top Rib and the Skin were examined to fit with the pilot hole and

were drilled with #30 drill bit

Next, the L angle and Slat Support were deburred and riveted to the Rib

Then the Ribs were clecoed to the bottom of the skin.

The Corner Doubler and Ribs were riveted to the bottom of the skin

Finally, all holes were riveted on the bottom of the skin