28 June 2011
INBOARD RIGHT SLAT ASSEMBLY
The bottom of the Slat Skin was drilled with a #40 drill bit and clecoed with #40 PWN Cleco series (zinc colour).
Later, the hole was expanded with #30 drill bit and clecoed with #30 PWN Cleco series (copper colour).
The Slat Rib and Slat Skin was clecoed using #40 Temporary Sheet Metal Fastener (red colour).
Next, the Slat Rib and Slat Skin were expanded with #30 Temporary Sheet Metal Fasteners (yellow colour).
The Slat was flipped over and clecoed with #40 PHD Cleco series.
Finally, all holes were clecoed on the Top of the Skin.
- Hits: 5