FLAPERON CONTROL

With a #30 drill bit, the holes were enlarged through left side skin and bearing support L angle.

#40 size holes was enlarged to #20 size holes through left side skin and through left upright (75F3-4).

#40 size holes was enlarged to #20 size holes to the right side skin through right upright (75F3-4) and bearing support.

#40 size holes was enlarged to #20 size holes to the right side skin through right upright (75F3-4).

#40 size holes was enlarged to #20 size holes to the right side skin, L angle and right bearing support.

#40 size holes was enlarged to #30 size holes through remaining holes along the L angle and right skin.

The L angle of the right bearing support was trimmed so that it fit under the baggage floor.

The L angle of the left bearing support was trimmed so that it fit under the baggage floor.