24 February 2014

FLAPERON CONTROL

 


As for today, we will continue to the assembly of the Flaperon Controls, 75-CA-1

The required bolts are shown as below


Parts

Hardware

Quantity

Torque value

In.lb

75C1-10, 75C2-2, 75C1-7, 75C2-1, 75C2-2

AN5-11A

SL NUTS

WASHER

4 each

120

75C1-6, CW5-12

AN5-11 A

SL NUTS
WASHER

1 each

120

Next, with a torque wrench, we torque the nut and bolt for the 75C1-10, 75C2-2, 75C1-7, 75C2-1, 75C2-2 on both part

 

Then, we torque the bolt for the next part 75C1-6, CW5-12 as shown in the picture below

 

 




25 February 2015

FLAPERON CONTROL

 

As for today, we will continue to the assembly of the Flaperon Controls, 75-CA-1

 


We put White Torque Seal on every SL NUTS that we have done yesterday

 


17 July 2014

FLAPERON CONTROL

 

Now, we will continue on the installation of the Torque Tube to the Forward Fuselage Assembly

 

And referring to the Photo Manual, This is the Front Torque Tube Bearing Rudder Fairlead (75C4-4) and Front Torque Tube Bearing (75C3-1)

 

The Failead is clamped inside the flanges of the bearing so the fairlead is flushed at the top. The Bearing is then back drill into the fairlead with a #40 drill bit and cleco

18 July 2014

FLAPERON CONTROL

 

Now, we have marked and drilled a hole 1-1/8” diameter for the Torque Tube to pass through the Fairlead. The Fairlead is checked does not need to contact the Torque Tube

 

Now we drilled through the Front Torque Tube Bearing to the Front Torque Tube Bearing Rudder Fairlead

 

Then we take our Torque Tube Bearing Support and arrange it to the assembly

  • 1
  • 2