FUSELAGE JOINING & FORWARD FUSELAGE SECTION

Today, we have plan to continue drilling through the Inboard Seat Belt Attachment, 75F13-7, and Right Armrest.

Close up, above is the picture that shows a hole with a point. We will drill through with #40 drill bit, then using a step drill for finishing.

As shown in the picture, we have drilled through the Seat Belt Attachment, 75F13-7, and Right Armrest.

Next, we continue to the Left armrest and Inboard Seat Belt Attachment.

We have made a point there, and we will drill with #40 through that point.

As shown in the picture, we have drilled with #40 drill bit and by using a step drill, we have enlarge the holes to be the same size with the hole on the Inboard Seat Belt Attachment. Then the holes are deburred for next priming process.

As shown in the picture, today we finished priming all the forward fuselage parts and we have let them dry in the room temperature.