Skip to main content

Uncategorised

18 July 2013

FUSELAGE JOINING & FORWARD FUSELAGE SECTION

Today, we have plan to continue drilling through the Inboard Seat Belt Attachment, 75F13-7, and Right Armrest.

 

Close up, above is the picture that shows a hole with a point. We will drill through with #40 drill bit, then using a step drill for finishing.

 

As shown in the picture, we have drilled through the Seat Belt Attachment, 75F13-7, and Right Armrest.

 

Next, we continue to the Left armrest and Inboard Seat Belt Attachment.

 

We have made a point there, and we will drill with #40 through that point.

 

As shown in the picture, we have drilled with #40 drill bit and by using a step drill, we have enlarge the holes to be the same size with the hole on the Inboard Seat Belt Attachment. Then the holes are deburred for next priming process.

 


As shown in the picture, today we finished priming all the forward fuselage parts and we have let them dry in the room temperature.

 


  • Hits: 3

Contact Us

PE Dr A. Halim Kadarman
Team Leader
  
Address:
School of Aerospace Engineering, Universiti Sains Malaysia
Nibong Tebal
Penang
14300
Malaysia

Telephone:     04-5995957
Fax:     04-5941025

  • Hits: 899

Committee

DCA APPROVED AIRCRAFT KIT BUILDER


Dr Abdul Halim Kadarman (Leader)(Engine)


Mr Mohamad Zihad Mahmud (Airframe)


Mr Ismail b. Mohamed Shorhami (Avionics)


Other team members

Mr Abdul Hisham bin Sulaiman


Mr Hasfizan bin Hashim


Mr Mohd Saiful Hasli bin Azizan

Mr Mohd Shukri bin Soaid


Mr Mahmud bin Isa


Mr Nor Ridwan bin Mohamed Yusuf


Mr Mohd Amir bin Wahab


Mrs Rahayu bt Dorahim@ Abdul Rahim


Mr Fauzan bin Jali


PRACTICAL STUDENTS ( May 2011 - September 2011 )

Azlan Shah bin Abdul Jalil

Ezly hafiz bin Khalid

Syafiq b. Suhaimi

Amira binti Ahmad

Ummi Masyitah bt. Mohd Fisol


  • Hits: 1441